(1962 Cadillac Superior Combination)
OK so I have used two cans of PB Blaster, pulling by hand, slide hammer, heating center with a torch, screw-type hub puller (broke it), porta-power cable puller. I even tried to rattle it with a flat air chisel while puller was on it.
The rear brake drum WILL NOT come off. :bonk:
I am afraid to put too much heat or pull from anywhere outside of the wheel studs. Anyone have suggestions?
OK so I have used two cans of PB Blaster, pulling by hand, slide hammer, heating center with a torch, screw-type hub puller (broke it), porta-power cable puller. I even tried to rattle it with a flat air chisel while puller was on it.
The rear brake drum WILL NOT come off. :bonk:
I am afraid to put too much heat or pull from anywhere outside of the wheel studs. Anyone have suggestions?