I'm not sure if anyone else out there has had any dealings with anything like this, I would Assume soo..........
Recently I started to take apart one of the Rear Doors on my Superior Ambulance (Remove Trim, Remove the Upper Section, Door Jam Gaskets.....You get the Idea)
So I rolled the Window down so I would have Easier Access to all the Various Screws and Bolts Holding the Top Section together.
And Once I Completed that I attempted to roll the Window Back up so I Could Remove the Outside Door Handle and Outside Key Lock along with any Trim I could Access with the Window Rolled up.
Only when I went to roll the window up it went up about a 1/4 of the way before it stopped and seemed to almost lock up.
I Haven't Applied too much Pressure to anything on the Window Regulator Assembly in Fear that something could Break, Bend, Bust or Get Stripped, Thus Resulting in needing to be Replaced.
The Window Crank/Handle does not spin Freely so I don't feel that its Stripped Out (Or at least I hope its not) But it Does Turn, and the Window does not move.
What I'm hoping this is, is something fairly common and simple to fix.
(Obviously)
I haven't done much to the Rear Door on the Other side but I'm sure I will Run into the Same thing,
As I'm sure the Rear Windows on this Car (Like Many) Haven't been Rolled up or down in YEARS!
Any Help or Insight you can Offer is GREATLY Appreciated!
Thanks YET again,
-Ryan
Recently I started to take apart one of the Rear Doors on my Superior Ambulance (Remove Trim, Remove the Upper Section, Door Jam Gaskets.....You get the Idea)
So I rolled the Window down so I would have Easier Access to all the Various Screws and Bolts Holding the Top Section together.
And Once I Completed that I attempted to roll the Window Back up so I Could Remove the Outside Door Handle and Outside Key Lock along with any Trim I could Access with the Window Rolled up.
Only when I went to roll the window up it went up about a 1/4 of the way before it stopped and seemed to almost lock up.
I Haven't Applied too much Pressure to anything on the Window Regulator Assembly in Fear that something could Break, Bend, Bust or Get Stripped, Thus Resulting in needing to be Replaced.
The Window Crank/Handle does not spin Freely so I don't feel that its Stripped Out (Or at least I hope its not) But it Does Turn, and the Window does not move.
What I'm hoping this is, is something fairly common and simple to fix.
(Obviously)
I haven't done much to the Rear Door on the Other side but I'm sure I will Run into the Same thing,
As I'm sure the Rear Windows on this Car (Like Many) Haven't been Rolled up or down in YEARS!
Any Help or Insight you can Offer is GREATLY Appreciated!
Thanks YET again,
-Ryan
Last edited: