View Single Post
Old 03-19-2017, 10:26 PM
John ED Renstrom's Avatar
John ED Renstrom John ED Renstrom is offline
PCS Member - Elected Director 2017-2020
Join Date: Mar 2009
Location: Hot Springs SD 57747
Posts: 11,429
Thanks: 4,064
Thanked 14,672 Times in 6,212 Posts
Groans: 2
Groaned at 3 Times in 3 Posts

easy enough to make a D out of any light. all they did was use the top plate and
turn it up side down. the three bolts would go threw it draw the bottom plate up till it's under the skirt. use 1/8 in piece of pipe for your center or drill down threw the approach size bolt. if yous has the hot shoe for a contact you will need to make a contact if yours is the wires you feed it down threw the hole . but a wing nut on the bottom and you now have a D. you can order a tag off ebay to even say so.

here is a pictures of a D I made using a piece of stainless for a bottom plate.
Attached Images
drop in for coffee anytime
Reply With Quote
The Following 3 Users Say Thank You to John ED Renstrom For This Useful Post:
Adam Borkat (04-07-2017), John Burchfield (04-21-2017), Kent Dorsey (03-20-2017)