PDA

View Full Version : WTB Federal Q2 Angled Base


Nicholas Studer
11-26-2016, 06:39 PM
Looking for the angled base for a Federal Q2 siren, like that pictured. It will be going on my 1970 C/B-Oldsmobile "Cotington 48" ambulance. http://www.professionalcarsociety.org/forums/showthread.php?t=16134

Please e-mail or PM me if you know of where one may be. Joe Dorgan is not a potential source. Thanks!

John ED Renstrom
11-26-2016, 07:17 PM
That one just has spacers under the back holes. It's a flat mount

Steve Loftin
11-26-2016, 07:38 PM
That one just has spacers under the back holes. It's a flat mount

It's a curved base, not flat.

John ED Renstrom
11-26-2016, 10:35 PM
True. But pull the rear spacers out it would mount on a flat surface.

Paul Steinberg
11-27-2016, 12:18 AM
True. But pull the rear spacers out it would mount on a flat surface.

There are no spacers in the rear, that is the way that the mount was casted. It might look like spacers in a picture, but the real thing has no spacers, unless you want to call the 1/16" rubber grommets that seal the bolt hole from water intrusion "spacers".

Nicholas Studer
11-27-2016, 11:17 AM
Thanks Folks! Someone has one they are willling to sell.

WAC: Please feel free to lock.

John ED Renstrom
11-27-2016, 01:01 PM
The only sloped ones I have played with were castings shaped like a door wedge. But I have a few with spacers . There was so much of this one or two year stuff and with there use on fire equipment different mounts for each one.they have been put on in a number of ways. All I ever did was make what I had fit what I needed it on.