PDA

View Full Version : 1969 Chevrolet Suburban M-M


Michael Catalano
07-04-2016, 06:17 PM
1969 Chevrolet Suburban, 1/2 ton, 350 CID small block with some ambulance equipment still present. Looks like a Wayne Sentinel to me, has a Miller-Meteor build plate inside the engine compartment. I know there is someone on here looking for one of these and this looks like a good candidate.

http://spokane.craigslist.org/cto/5666211894.html

John ED Renstrom
07-04-2016, 09:36 PM
standard AC missing and after market intake and carb.

Paul Steinberg
07-04-2016, 10:17 PM
that looks like a non air car. No vents on the dash.

John ED Renstrom
07-04-2016, 11:02 PM
Box on the fire wall was what I was seeing

John ED Renstrom
07-04-2016, 11:05 PM
Big box on the fire wall was what I was seeing

Steve Loftin
07-05-2016, 10:39 AM
To my knowledge Wayne didn't stock any of these chassis with factory air. They stocked 1/2 and 3/4 ton Suburbans with no A/C and used aftermarket air when needed.

If desired, a customer could special order one with factory air.

John ED Renstrom
07-05-2016, 10:43 AM
I just remember the heater box being flat on the firewall if there was no AC. The 70 was the only one I had with factory air.

Michael Catalano
07-05-2016, 08:12 PM
As I understand it, normal factory A/C in this era Suburban was ducted through a roof mounted arrangement that exited above the rear doors. There were no dash vents unless you ordered the A/C with the non-RPO option code 9947AA - "A/C Conversion" which brought it in thru dash vents similar to those used in the pickups. My 1971 has this code on the SPID label and the dash vents as well as the plumbing that goes thru the partition and into the aftermarket Mark IV A/C in the rear compartment.