PDA

View Full Version : 1957 Chevrolet Hearse Frame Question


Eric Huffstutler
11-24-2014, 03:57 PM
This may have been asked before but does anyone know the frame configuration layout for the 1957 Hearses - either National or Stagecoach made? Thanks!

Eric

John ED Renstrom
11-24-2014, 10:34 PM
they would have been a stretched stock frame. with normally a crossmember added were the carrier bearing was put for the stub end of the drive shaft. the arches cut flat over the rear axle for the flat floor. as far as I know C/B was the only one that built a complete center section for there stretched cars.